|Date Added:||15 July 2005|
|File Size:||38.84 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
S4M Industrial Printer Support
ID Card Printer Ribbons. Also available as a case Part If using a hole or notch position the sensor’s red light directly under the hole or notch so it is seen as the labels feed. Not all media is the same when it comes to being compatible with your application or needs.
This is referred to as Thermal Transfer printing where an inked ribbon is used to produce the image on the label. Thermal transfer, dpi4. Cables To Go Cables Serial printer cable, 9-pin to pin, 6ft.
Download Zebra S4M Driver
All printer settings can be impacted by commands from a mis-matched or misconfigured zgc or software application. The S4M printer comes from the factory set to tear-off mode and adjusted for full with paper label technologis with wax ribbon. Zebra Z-Perform T 4″ x 6″ Thermal transfer paper label.
Printhead Pressure You may need to adjust printhead pressure if printing is too light on one side, if you use thick media, or if the media drifts from side to side during printing.
Label Length Max setting. Download drivers for the Zebra S4M Printer: Avoid over heating the ribbon as it can melt if set too high.
This is used for media that is not compatible with the Reflective Gap sensor, typically media with dark pre-print. Saves the value Send the file using your utility or application.
Zebra S4M Printer – Best Price Available Online – Save Now
A printer that is functioning fine after setup but fails or indicates an error after label requests are received are most likely affected by the host side misconfiguration of the driver or printer software settings.
Ships in Days. You can simply remove the item from your cart. This applies to applications where the use of ribbon is required. Uneven pressure will cause ribbon wrinkle, poor print quality, and horizontal media drift.
This is related to the label presentation after printing and limited to the options you have installed. Download Zebra S4M driver. The printer comes with two sensors for label tracking based on the Media Type used.
We love to talk about barcoding! Ribbon Loading – The printer uses uses a reflective plate and an sensor that shines and receives light to detect the presence of ribbon.
This can be an inter-label gap, a hole, notch or Black Mark. The S4M is perfect for these situations as they can handle the technoloogies volume without breaking the bank.
The Media and Ribbon if used capabilities. When using typical labels on a backing with an inter-label gap, the sensor can be positioned along the width of the label as long as it is not over the rounded edge.
For example, on a dpi printer using a 6″ label, set the Maximum Length value to 7″. Programming commands can be entered into a file and communicated to the printer, received as an technolgies through a driver from an application, or created using one of many Zebra Label Software packages on the market.
USB – A Zebra compatible driver must be installed before connecting the printer. Future printers will support EPL but there will be no command enhancements.